Table of Contents
Advertisement
Figure: 9 Mounting the
UX302
Mounting the
Antenna Module
•
Horizontal Mounting position.
1
Align the UX302 stud holes with the holes on the mounting surface.
2
Secure the unit with M5 nuts with a minimum length of 12 mm. Tighten the nuts
to the recommended tightening torque of 7.0 kgf.cm (6.1 lbf.in).
3
Connect flexible tubing with a 9 mm inner diameter to the drain nozzle at the
bottom of the UX302 (see
appropriate drainage area.
The nozzle drains water out of the bezel area through the flexible tube.
Ensure that the tubing is properly dressed and mounted as vertically as possible
(without any loops) to ensure smooth water drainage.
The front view of the UX402 Antenna Unit shows the following. The
customer-view indicator LEDs denote a successful transaction with an
Installation Guide
) and place the other end of the tubing at an
Figure 2
UX302 and UX402
15
© VeriFone, Inc. All rights Reserved.
Advertisement
Table of Contents
