Download Print this page

Kenwood BC-15 Instruction Manual page 3

Rapid charger

Advertisement

Front Panel
To AC outlet
===
(Illustrations show the U.S.A. version.)
(2) Charging the battery alone.
Fit the
NiCd
battery
with
the
holder
before
inserting the pack into the charger (except for
PB-14).
To AC outlet
—==CFE
4. lf the battery has been
properly inserted
into the
charger the INDICATOR
will turn RED, signaling
proper operation.
—>
(The INDICATOR will light depending on the residual 4—
MoT2
charge on the battery.)
5. When
the
battery
has
reached
full charge
the
INDICATOR
will change
to GREEN.
It will require
approximately 1 hour for this to occur.
6. Tilt the battery as shown
and pull out it from the
charger.
7. Disconnect AC adapter from an AC outlet after the
oe
~
battery has reached full charge.
CAUTIONS
1. The BC-15 is for charging the battery only. Do not
attempt to operate the radio while it is inserted into
the charger and the power switch is turned ON.
2. For operator safety, do not charge the transceiver
in the mobile.
3. For this product
use
the
attached
AC
adaptor
(conforming
to EIAJ. with plug of unified polarity
type).
Use of other AC adaptor may induce troubles.
HM MAINTENANCE
INSTRUCTIONS
1. Do not use the BC-15 in high-temperature or high-
humidity environments,
in direct sunlight, or near a
heater.
2. Do not subject
the BC-15
to undue
vibrations
or
impact.
3. Make
sure that the NiCd
battery pack, the BC-15,
and
the power
source
are
properly
installed
and
connected.
4. Clean both terminals of the NiCd battery packs and
the BC-15 with a soft cloth before charging.
5. NEVER
USE
SOLVENTS
SUCH
AS THINNER
AND
BENZINE FOR CLEANING.
re
Jp ce sent S00 olay
inion CER )
T hey ofl, %
>
Wagon
PBESD

Advertisement

loading
Need help?

Need help?

Do you have a question about the BC-15 and is the answer not in the manual?

Questions and answers