Advertisement
CONNECTION
+ Connect the Studio Cable WV-CA26U15, WV-CA26U30 or WV-CA26U100 with the conversion cable WV-CA26720 between
the Remote Connector of the camera and the Camera Connector(31) of this unit.
* Connect the 15-pin multi cable between the pan/tilt unit or lens control.
Biack Burst
ita
Gen-
AUX IN
WV-RC550
lock
VIDEO OUT
WV-CA26U15
WV-CA26U30
WV-CA26U 100
Key Camera
.
=
Gen-lock (Composite Sync}
VIDEO OUT
Studio Camera
AUX
| vipeo
OUT
Gen-
WV-RC550
lock
JA
Pre View
'Program
JEE
e—a —
Lessee
|
Lesser
e]
Line
Video Signal
Di
Tally 8 Intercom
Intercom
Special Effects
Generator
a
WV-RC550
WV-CA26U 15
WV-CA26U30
WV-CA26U 100
For Gen-lock
Notes:
+ Connect
the
Studio
Cable
WV-CA26U15,
WV-
CA26U30 or WV-CA26U100 with the conversion cable
WV-CA26T20
between the Remote Connector of the
camera and the Camera Connector(31) of this unit.
e Connect the coaxial cable for the gen-lock signal
between the black burst output on the production sys-
tem and Gen-lock Input Connector on this unit. (The
signal may be bridged or looped through to another
RCU.)
e Connect
the coaxial
cable
for the lineview
signal
between the effect output connector on the production
system and the Auxiliary Input Connector on this unit.
(the signal may
be bridged or looped
through to
'
another RCU.)
-10-
1. The Tally Light and intercom between the camera,
RCU
and Special Effect Generator will function
only when the 4-pin cable for the Tally Light and
Special Effects Generator.
The studio cable can be extended
up to maxi-
mum of approximately 330 ft (100m).
. The Subcarrier Phase Coarse, Fine Controls and
the Horizontal Phase Control on the RCU should
be set to match other camera in the system. Refer
to the Operating Instructions of WV-F500 or WV-
F700 series for details.
Advertisement
