Panasonic WV-RC550 Operating Instructions Manual page 11

59.
60.
61.
62.
63.
64.
65.
Up Switch (UP)
This switch is used to increase the set value of the
desired item pointed out by the cursor.
Item Switch (ITEM)
This switch is used to choose the item in the set up
menu.
Page Switch(PAGE)
This switch is used to choose the desired set-up menu
from the available menus.
Initial/User Set Switch (OFF/1/2)
This switch selects Encoder output or EVF (black and
white) output from the Video Output Connector and
whether the User Set Function is available as follows:
OFF: Encoder is output from the Video Output
Connector (35) and the Initial/User Set function is
available.
1: Encoder is output from the Video Output
Connector (35) and the Initial/User Set function is
available.
2: EVF (black and white) signal is output from the
Video Output Connector (35) and the Initial/User
Set function is available.
Chroma Gain Fine Control (CHROMA ADJUST)
This control allows for fine adjustment of the chroma
signal level for matching the chroma levels of all the
cameras in a system. Adjust this control only after hav-
ing set the Cable Length Compensation Switch (65) to
the correct position.
Luminance Gain Fine Control (Y ADJUST)
This contro! allows for fine adjustment of the lumi-
nance signal level for matching the levels of all cam-
eras in a system. Adjust this control only after having
set the Cable Length Compensation Switch (65) and
the Luminance Gain Fine Control (24) to the correct
position.
Cable Length Compensation Switch
(COARSE, 1/2/3/4)
This switch is used to compensate for extensive cable
lengths used with the 26-pin multi-cable between the
camera and Remote Control Unit (RCU).
1. Use for cable length of less than 225 ft (75m)
2. Use for cable length of 225-450 ft (75-150m)
3. Use for cable length of 450-690 ft (150 230m)
4. Use for cable length of 690-900 ft (230 300)
66.
67.
68.
69.
70.
Subcarrier Phase Fine Control for Gen-lock
(SC FINE)
This control allows for adjustment of the camera signal
subcarrier phase from 0° to 360° to match the phase
with that of the burst signal at the Gen-lock Input
Connector in a system configuration.
Subcarrier Phase Coarse Control for Gen-lock
(SC COARSE)
The coarse control adjusts the subcarrier phase from
0° to 360° in 90° steps, while the fine control allows for
continuous fine adjustment over a range of 90°.
Horizontal Phase Control for Gen-lock (H PHASE)
The horizontal phase of the camera signal can be
adjusted to much the horizonta! phase of the signal at
the Gen-lock Input connector.
Intercom Level Control (INTERCOM, LEVEL)
Use this control to adjust the volume level in the head-
set connected to the Intercom Jack (70).
Intercom Jack (INTERCOM)
This jack is used for communications between the
camera operator and Remote Control Unit (70) opera-
tor in a system configuration with a Special Effects
Generator.
For the Rear Panel, Refer to Number 31 - 38 listed
on page 5.