Request To Exit; Data Logging - Viking K-1900-8 Technical Practice

Apartment/office entry controller

Hide thumbs Also See for K-1900-8:

Technical practice (8 pages)

Application note (4 pages)

Product manual (4 pages)

Table of Contents

D. Ring-Thru Mode

If the Ring-Thru mode is selected (see Programming section J), incoming calls are allowed to ring through the C-4000

to Entry Phone 1. If that door phone has an auto-answer feature, this will allow the user to "monitor" that entry way.

The C-4000 is still watching for the security code and will seize the line if a valid code is detected. In this manner, the

C-4000 may still be remotely programmed. In this mode the relay activation code may also be used to buzz in approach-

ing guests. If the Ring-Thru mode is turned off, the C-4000 will answer all inbound calls and watch for the security code

for remote programming. Note: To utilize the Ring-Thru mode with a K-1700-3 entry phone, DIP switch 5 on the K-1700-

3 must be in the ON position (Fax Back Document 157).

E. AUX Line

Any tenant phone number that is programmed with a leading "

tions instead of the "C.O." connections. The ability to dial out on one of two lines provides additional flexibility to some

unusual installations. For example: Some tenants do not have C.O. phone service, so a Viking C-3000 is used to ring

those tenants phones, or some tenants phones are on PABX extensions, so the "AUX" line can be wired to that PABX

for extension dialing. Note: When using a C-3000 with the C-4000, the relay activation code in the C-3000 should be

"disabled" by accessing the programming mode of the C-3000 and dialing "##4".

F. Request to Exit

If a "Push to Open" button, push bar switch, key switch, motion sensor, etc. provides a momentary contact closure to

the Request to Exit screw terminals, the door strike relay will activate. This can be used for a receptionist to allow

entry for visible guests, activate a gate for exiting tenants, provide key access for postal service, etc.

G. Data Logging

Each time there is an entry point event, the C-4000 will transmit 1200 baud ASCII data out of its LOG BUS screw ter-

minals. An example of 5 different entry events is shown below. The C-4000 outputs entry event data in real time, but

does not time stamp.

Examples:

Valid Card Entry ...........................

Non-Valid Keyless Attempt .........

Valid Keyless Entry ......................

A guest was granted entry by .....

tenant in memory location 007

Entry Point ID Number

If the entry attempt Valid (V)

or Not Valid (N)

H. Entry Logger Software

Visit www.vikingelectronics.com to download free ENTRY LOGGER software. The software provides transaction log-

ging for the ES-1 and C-4000 Entry Controller systems. Compatible with any Windows based PC running Windows 98

or higher, the software adds time and date stamps to each transaction, and allows user printing, record saving, and

complete search capabilities.

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or

subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate

such changes.

Fax Back Doc 164

Simulated LOG BUS Output