Table of Contents
Advertisement
7. System and Operations Set Up
B-1. Macro Programming:
There are three type of macro functions you can program. They are as
follows:
1. M1, M2 and M3 in the Main menu:
Designed to send out up to twenty eight commands from each of the
three buttons.
2. Twelve device buttons in the Main menu:
Send out up to fourteen commands from each device button.
3. Favorite Channel Buttons:
You can create and design up to 60 buttons as your Favorite Button in
video modes. Each favorite channel button can send out up to
fourteen commands with one button press.
B-2. To Program Macro Functions:
Press MACRO PROGRAM button in 2. SYSTEM & OPTIONS
Move the cursor on the LCD either to the COMMON BUTTON to
program M1 Ð M3 and favorite channel buttons or to the DEVICE
BUTTON to program the device buttons by using MUTE button.
1) For M1 Ð M3 Button:
1. Press one of the three macro buttons, M1 Ð M3, with the cursor
on DEVICE BUTTON.
2. Select functional buttons you wish to store in the macro button.
You can store up to 28 commands.
3. Store the commands you selected to the macro button by pressing
CH (UP) button. To cancel the macro commands, press CH ( DOWN ).
17
7. System and Operations Set Up
2) For Device Buttons:
1. Press one of the twelve device buttons you wish to store macro
functions with the cursor on DEVICE BUTTON.
2. Move the cursor to COMMON BUTTON and select again either
the same or another device button whose functional buttons you
wish to store in the device macro button you selected first. You
can store up to 14 commands into the device macro buttons.
3. Store the commands you selected to the macro button by pressing
CH (UP) button. To cancel the macro commands, press CH ( DOWN ).
3) For Favorite Channel Button:
1. Press the device you wish to program favorite channels with cursor
on COMMON BUTTON.
2. Press one of the favorite channel buttons and enter the channel
number you wish to store in the
FAVORITE channel button. You can store up to 14 commands.
3. Store the commands you selected in the Favorite channel button by
pressing Channel UP button. To cancel the macro commands, press
CH ( DOWN ).
Once you complete the macro programming and wish to exit, press
both the MAIN and PAGE buttons simultaneously. This will take you
to the setting mode. Move the cursor to 8. TO EXIT in setting mode
and press the cursor down to exit or simply press the MAIN button to
exit to main menu.
NOTE:
Pressing the Volume Up button during the macro programming will
add a time delay of 0.5 seconds between the commands. E.g. Pressing
the Volume Up button twice will cause a pause of 1 second between
the commands where the delay was inserted.
B-3. To Erase Macro Functions.
To erase the functions you stored in any of the macro buttons, press
the Channel UP button without entering any commands during the
macro programming mode.
18
Advertisement
Table of Contents
