then attempts to synchronize with the MSF
radio signal at 3.00 am and 4am.
The clock can be set to scan the radio signal
manually by holding "
seconds. Each reception takes around several
minutes. If receptions fail, scanning stops.
("
" on LCD disappear) and repeats again
on next full hour. E.g. scanning failed at
8:20a.m. It will scan again at 9:00a.m.
Stop scanning MSF radio signal by holding
"
" button (B5) for 3 seconds.
"DST" shown on the LCD if it is in Daylight
Saving Time Mode
Note: All Setting mode will automatically exit in
around 15 seconds without any adjustment
5. Lock buttons
Hold "▼" (B2) and "▲" (B4) button at the
same time for 5 seconds to lock the rest
buttons. When rest buttons' functions been
locked, icon " " displayed. Hold "▼" (B2)
and "▲" (B4) button 5 seconds again to
unlock.
6. Precautions
The clock loses its time information when
the battery is removed.
Use a pin to press the reset button if the
Unit does not work properly.
Do not expose it to direct sunlight, heavy
heat, cold, high humidity or wet areas
Never clean the device using abrasive or
corrosive materials or products. Abrasive
cleaning agents may scratch plastic parts
and corrode electronic circuits
" button (B5) for 3
3