Table of Contents
Advertisement
Installation -
Remote smart controller
1. Ensure power supply is switched off
2. Remove the mounting plate from the controller
by inserting a small screwdriver into slots at
base of controller. See Fig 2.
3. Fix the mounting plate to the wall using either
a recessed or surface mounted back box using
the screws provided. See fig 3.
4. Connect power supply, connect wires into the
appropriate terminals on the controller.
See Fig 4.
5. Fasten body of thermostat and the mounting
plate. See Fig 5.
6. When using external pattress box assemble as
shown. See Fig 6.
87
44
87
56
ON
OFF ON
OFF
OFF
OR
ON
Fig. 1
UP
60
Fig. 3
14 | SmithsEP.co.uk | Issue 001 - October 2023
17
47
30
S2 COM S1
SALUS
FC600
50
F3 F2 F1 V2 V1 N L
60
Fig. 2
SALUS
S2
COM
S1
FC600
F3 F2 F1 V2 V1 N L
Fig. 4
Fig. 5
Connecting remote smart
controller to the heater
1. Feed the connector end of the wire harness
through the cut outs in the back or underside
of the unit.
2. Plug in the wire harness connector block to the
female connector block situated on the heater
electrical; panel as shown in Fig 7.
3. Connect the earth connector to the earth tag
on the wiring panel adjacent to the connector
block as shown in Fig 7.
Fig. 7
Remote sensor wiring
Remote sensor may be used where the thermostat
will remain internally to the unit. See wiring
diagram S2 and C connections.
Master/slave wiring, hard wire
A number of units may be controlled from one
thermostat. For connection details please see
wiring diagram on page 12.
Note:
Maximum units:
Maximum total distance (Cable):
Fig. 6
4
40 metres
Advertisement
Table of Contents
