U-Line Echelon CO2175FF Installation Manual
Echelon series ice maker/refrigerator
Hide thumbs
Also See for Echelon CO2175FF:
- Specifications (2 pages) ,
- Use and care manual (28 pages) ,
- Installation instructions manual (6 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Related Manuals for U-Line Echelon CO2175FF
Summary of Contents for U-Line Echelon CO2175FF
-
Page 1: Installation Guide
Installation Guide CO2175FF — ® Combo Ice Maker/Refrigerator www.U-LineService.com Phone (414) 354-0300 • FAX (414) 354-7905 Service & Parts Tech Lines Phone (800) 779-2547 • FAX (414) 354-5696 OnlineService@U-Line.com ©2006 U-Line Corporation 08/2006... -
Page 2: Table Of Contents
CO2175FF — Combo® Ice Maker/Refrigerator Contents Exterior Cleaning ......Cut-Out Dimensions ...... -
Page 3: Inspect And Plan
CO2175FF — Combo® Ice Maker/Refrigerator 2 Inspect and Plan You have received a carton containing your CO2175FF Ice Maker/Refrigerator with a package inside containing a Use and Care Guide, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www.U-LineService.com. -
Page 4: Exterior Cleaning
3 Prepare Site Your U-Line product has been designed for either free- standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for water, drain and electrical connections in the rear. -
Page 5: Product Dimensions
Door Swing Black and White Figure 3 08/2006 CO2175FF — Combo® Ice Maker/Refrigerator Reversing the Door (Black and White Units Only) All U-Line units (except Stainless Steel models) may be left- or right-hand opening. The door opening is easily 34-1/8"... -
Page 6: Other Site Requirements
For more information see Page 13. Environmental Requirements Many U-Line models are designed to operate in harsh outdoor/marine environments. Special considerations include the following: • The units are designed to operate between 50°F (10°C) and 110°F (40°C). -
Page 7: Side-By-Side Installation Instructions
Side-By-Side Installation Instructions For a complete refreshment center, install your CO2175FF Ice Maker/Refrigerator beside a U-Line Drawer or Wine Captain Model (see Figure 11 for typical cut-out). Note that each Side-By-Side Installation will be different. • Cut-out width for a side-by-side installation is the total of the widths listed under Cut-Out Dimensions in each unit’s Installation Guide. -
Page 8: Full Overlay Door Panel
Full Overlay Door Panel Door Panel Preparation A full overlay door panel completely covers the doorframe and handle to give a built-in appearance. See your U-Line dealer for the optional Full Overlay Door Panel Kit. 2175 Models: P/N U-OL2175B -- Black P/N U-OL2175W -- White 2115 &... - Page 9 It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed. 08/2006 CO2175FF — Combo® Ice Maker/Refrigerator Installation Instructions Removing Existing Door 1. Remove the door shelves by first pulling shelves up at a 45°...
- Page 10 CO2175FF — Combo® Ice Maker/Refrigerator Drill ø 5/32" x 3/8" Deep 7 Places Model 2175 6 places Model 2115 and CLR2160 For use with #10 x 5/8" Wood Screw and Nylon Spacer 1" 11-7/8±1/32 For use on Model 2175 Only...
-
Page 11: Checking Door Alignment
9. Reinstall the door shelves by lining up the bosses and first pushing straight in, then down at a 45° angle. 08/2006 CO2175FF — Combo® Ice Maker/Refrigerator Checking Door Alignment The unit’s door is aligned at the factory before shipment. -
Page 12: Checking Door Alignment
CO2175FF — Combo® Ice Maker/Refrigerator 5 Adjust Door Checking Door Alignment The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation. IMPORTANT Properly aligned, the door should be 1/8" below the top of the unit’s cabinet, NOT flush with the top (see Figure 28). -
Page 13: Water Supply Connection
(see Figure 34). However, make certain that the tubing is not pinched or damaged during installation. Note: U-Line recommends the use of copper tubing for installation. The use of other types of tubing is not recommended due to potential aftertaste & deterioration over time. -
Page 14: Electrical Specifications
CO2175FF — Combo® Ice Maker/Refrigerator 7 Prepare Power Supply Electrical Specifications CAUTION Electrical installation must observe all state and local codes. This unit requires connection to a grounded (three- prong), polarized receptacle that has been placed by a qualified electrician. -
Page 15: Installation Of The Co2175Ff
Relocating the Shelves Both the glass shelves in the refrigerator and the inner door shelves can be moved to accommodate your bottles, cans and containers. Glass Shelves on Right-Hand Hinge Units 1. -
Page 16: Initial Start-Up
(24) hours of operation. CAUTION • The ice bucket MUST be fully inserted to avoid freezing products in the refrigerator section. The ice bin door must be fully closed with the door lip inside the ice bucket. • Do not place cans or bottles so they are touching the back wall of the refrigerator section, as they may freeze. -
Page 17: Service Information
For more than four decades, U-Line has distinguished itself as the leader in built-in undercounter ice making, refrigeration and wine storage appliances. U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in ®...