Table of Contents
Advertisement
Replace the back cover by pushing it down into its
slots, until it stops.
The first time you insert an SD/MMC card into your
phone, it is formatted for compatibility. Folders for
your photo, video, audio, and other files are created
automatically. If you have any prior existing data on
the card, it may be lost.
To use the SD/MMC card as the default storage
location for your data files, under your phone
set the
Default Storage
option to
more information on this, please refer to page 54.)
Finally, to remove the SD/MMC card, gently press
the top of it inside its slot. When it pops up, you may
remove it from the phone.
8
Settings
Memory
Card. (For
Switching on the phone
To switch on the phone, long press the
the PIN code if required (i.e. the 4- to 8-digit secret
code of your SIM card). It is preconfigured and
communicated to you by your operator or retailer. For
more information on PIN codes, see "Security" on
page 54.
If you enter an incorrect PIN code 3 times, your SIM
card will be blocked. To unblock it, you must request
the PUK code from your operator.
Charging the battery
Your phone is powered by a rechargeable battery. A
new battery is partially charged and an alarm will warn
you when the battery level is low.
Once the battery and the battery cover are clipped on
the phone you can charge the phone. Pull away the
protective rubber cap covering the charger connector
(it is attached to the phone so that you cannot lose it).
Plug in the connector as shown below. Then plug it
into a main AC power socket.
)
key. Enter
Getting Started
Advertisement
Table of Contents
