Table of Contents
Advertisement
NOTE: Be sure the AC POWER switch is turned OFF
when making all signal and speaker connections.
nm
O Ou»
"nmm
О our»
FRONT
PANEL
A.
Pan This knob feeds the input channel signal to a
pair of mix buses to create the stereo program mix
(Left and Right program buses}. The stereo program
bus then feeds the Speaker, Line, and Headphone
outputs via the Master Program faders.
Monitor 1 Send (Rev/Echo) This knob feeds the
input sianal to the mix bus which, in turn, feeds the
Monitor 1 output. The same bus also drives the
built-in reverb or external reverb/echo (effects)
units; the send is post-EQ and fader.
Monitor 2 Send This knob feeds a pre- EO and pre-
fader signal to a second monitor mix bus which,
in turn, feeds the Monitor 2 output.
. High and Low EQ Controls These continuously
adjustable knobs allow for +15 dB of bass and
treble equalization on each input channel. Response
is "flat" at center position.
|
F.
c AC
Input Level Selector Switch This switch adjusts the
input channel's sensitivity for best results with
different input sources. For Models EM-10011 and
EM-150!1B this switch is а 3-position slide switch
(Line/Instr/Mic). On the EM-200B and EM-300B,
the level switch is a b-position rotary knob.
Channel Fader On Models ЕМ-10011 and EM-15011B
rotary faders set the mix level of each channel.
Models EM-200B and EM-300B have smooth linear
slide faders that also provide a good visual indication
of the mix-level for each channel.
. VU Meters Two meters indicate the average speaker
power output level. On the EM-300B, an additional
set of meters indicates the average output level of
the two Monitor mix buses. The meters are
illuminated when AC POWER is ON.
Advertisement
Table of Contents
