Changing The Steering Ring - Vinten Quattro SL Operating Instructions Manual

Changing the steering ring

(Fig 5)
The Quattro SL may be supplied with a 58.9 cm (23 in.) or 74 cm (29 in.) diameter steering ring with either
rivets or moulded steering indicators.
NOTE: If a steering ring with a moulded indicator is changed for one with rivets, or vice versa, it
will be necessary to realign the steering mechanism. This should be carried out by
competent personnel in accordance with the procedures laid down in the Maintenance
Manual.
To change the steering ring:
Fully extend the column and apply the on-shot clamp.
On the underside of the steering hub, remove four nyloc nuts (4.1) to release the steering ring (4).
Note the position of the steering indicators (21) and remove the steering ring.
Position the replacement steering ring on the steering hub with the steering indicator in the position
noted above.
Secure the steering ring with four nyloc nuts (4.1).
English
19