Safety Measures - Vitek VT-1185 Manual Instruction

THERMOPOT VT-1185
An electric thermopot is intended for boiling wa-
ter and maintaining the required temperature of
water.
DESCRIPTION
Removable upper lid
1.
Lid opening button
2.
Steam outlets
3.
Inner lid
4.
Sealing gasket
5.
Maximal water level mark «FULL»
6.
Control panel
7.
Automatic water dispense button
8.
«DISPENSE | Налить»
Dispensing spout
9.
Water tank
10.
Carrying handle
11.
Body
12.
Water level scale
13.
Minimum water level mark «MIN»
14.
Power cord connector
15.
Power cord
16.
Control panel (7)
Water heating off indicator «OFF | ВЫКЛ»
17.
Power on indicators («ON | ВКЛ»)
18.
Water dispensing lock indicator
19.
«UNLOCK | Разблокировка»
«CLEAN | Очистка» indicator
20.
Water boiling indicator «BOILING | Кипячение»
21.
Water temperature maintaining mode indicator
22.
«KEEP WARM | Подогрев»
Water heating temperature selection
23.
indicators (°C)
Display
24.
Clean mode on button «CLEAN | Очистка»
25.
Water heating temperature selection button
26.
«T°C SET | Выбор T°C»
Reboiling mode on button
27.
«REBOIL | Повторное кипячение»
Water dispense locking and unlocking button
28.
«UNLOCK | Разблокировка»
ATTENTION!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal opera-
tion current not exceeding 30 mA, to install RCD,
contact a specialist.

SAFETY MEASURES

Before using the unit, read this manual carefully
and keep it for future reference.
Use the unit for its intended purpose only, as speci-
fied in this manual.
•
Mishandling the unit can lead to its breakage
and cause harm to the user or damage to his/
her property.
•
Make sure that the operating voltage of the unit
corresponds to the voltage of your mains.
•
The power cord is equipped with a «euro plug»;
plug it into the socket with reliable grounding
contact.
•
To avoid fire or electric shock, do not use adapt-
ers for plugging the unit in.
•
Do not use the unit in bathrooms. Do not use it
near swimming pools or other containers filled
with water.
•
Do not use the unit in places where aerosols are
sprayed or highly flammable liquids are used.
•
Do not use the unit outdoors.
•
Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
•
When unplugging the unit, always pull the plug
but not the cord.
•
Never leave the operating unit unattended.
•
Do not switch the thermopot on if it is empty.
•
Do not drop or tilt the unit.
•
Be careful when using the thermopot to avoid
getting water on the electrical connector.
•
Use the thermopot only for water boiling; it is
prohibited to heat or boil other liquids in it.
•
Ensure that water level in the thermopot is
not below the «MIN» mark and not above the
«FULL» mark.
•
Do not fill the thermopot with water directly
from the faucet; to fill the thermopot use a suit-
able bowl.
•
Place the thermopot on a flat dry and stable sur-
face; do not place the thermopot on the edge
of the table.
•
Do not place the thermopot next to the walls or
close to the kitchen furniture.
•
Place the thermopot keeping at least 20 cm gap
between the thermopot body and the wall and at
least 50 cm gap above the thermopot.
•
Do not use the unit near heat sources and open
flame.
•
Do not let the power cord hang from the edge of
the table and make sure it does not touch hot or
sharp edges of furniture.
•
Do not open the lid and do not pour water out
during boiling. Be careful when you open the lid
right after water boiling.
•
Do not rotate the unit during water pouring.
9
ENGLISH