Sound And Vibration; Before Starting The Equipment; Operation - Toolson PRO-AS 12 Li Original Operating Instructions

Anleitung_PRO_AS_12_Li_SPK7__ 23.10.12 10:05 Seite 12
GB

Sound and vibration

Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Drilling in concrete
Vibration emission value a
h
K uncertainty = 1.5 m/s 2
Screwing without hammer action
Vibration emission value a
h
K uncertainty = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
12
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
65.3 dB(A)
1. Lung damage if no suitable protective dust mask
3 dB
2. Damage to hearing if no suitable ear protection is
76.3 dB(A)
3 dB
3. Health damage caused by hand-arm vibrations if

5. Before starting the equipment

Be sure to read the following information before you
use your cordless screwdriver for the first time:
≤ 2.5 m/s 2
1. Charge the battery pack with the charger
2. Only ever use sharp drill bits and screwdriver bits
≤ 2.5 m/s 2
3. Always check for concealed electric cables and

6. Operation

6.1 Charging the LI battery pack (Fig. 2-3)
1. Pull the battery pack (5) out of the handle,
2. Check that your mains voltage is the same as that
3. Insert the battery pack (5) into the battery charger
4. In section 10 (Charger indicator) you will find a
If the battery pack fails to become charged, please
check
n
n
is used.
used.
the equipment is used over a prolonged period or
is not properly guided and maintained.
supplied. An empty battery pack requires a
charging period of approximately 1 hour.
which are suitable for the purpose and in
faultless condition.
gas and water pipes when drilling and screwing
in walls.
pressing the pushlock buttons (8) as you do so.
marked on the rating plate of the battery charger.
Insert the power plug of the charger (6) into the
mains socket outlet. The green LED will then
begin to flash.
(6).
table with an explanation of the LED indicator on
the charger.
whether there is voltage at the socket-outlet
whether there is proper contact at the charging
contacts on the charger.