3.2.2 Operation from the control panel
This section describes how to start/stop the motor, and set the operation frequency with the operating panel.
▲
▼
RUN
STOP
★For coast stop
Change the setting of the parameter
.
Motor speed
★The operation frequency can be changed
anytime even during operation.)
■
Change the settings of the following two parameters first from the operating panel.
:(Control panel: Parameter determining the operation mode)
:(Control panel: Parameter determining the input mode of speed reference)
[Setting procedure]
Key operated
MON
▲ ▼
ENT
▲ ▼
ENT
▲ ▼
ENT
▲ ▼
ENT
*To return to the standard monitor mode (operation frequency), press MON key.
:
Set the operation freq.
:
Start the motor
:
Stop the motor.
(Deceleration stop)
Coast stop
LED display
⇔
⇔
[Control panel operation]
Ex. of typical connection
MCCB
R/L1
Power
S/L2
supply
T/L3
G/E
CC RX VI RR PP
The running frequency is displayed. (Make this setting when the
motor is out of operation.)(If the monitor display mode setting
parameter is set at [Running frequency].)
Press the [MON] key to call up the first basic parameter
(automatic acceleration/deceleration).
Select "" by pressing the △ or ▽ key.
Press the Enter key to display the parameter setting.
(Default setting: )
Change the parameter setting to (Operating panel enabled)
by pressing the △ key.
Save the change by pressing Enter key. Then, and the
set value are displayed alternately.
Select "" by pressing △ key or ▽ key.
Press the Enter key to display the parameter setting.
(Default setting: ).
Change the parameter setting to (Operating panel input). by
pressing the △ key.
Press the Enter key to save the change. Then, and the
set value are displayed alternately.
C-6
U/T1
V/T2
W/T3
F
ST
Shipped
Control panel
with these
R
terminals
shorted
CC
I I
Operation
Motor
IM