Toshiba TOSVERT VF-P7 Instruction Manual page 167

■Setting of operation command (RS485)
Title Function
Operation command

mode selection
Note) To use inter-drive communication (),  can't be set at  for slave inverter.
■Setting of speed reference (RS485)
Title Function
Speed setting mode

selection
■Communication parameters (standard RS485)
These parameters are used to set or change the data transmission speed, the parity, inverter
numbers and the communication error trip timer with the control panel and or a linked control.
Title

Parity(common serial/RS485)

Inverter number
Communication time-out

(common serial/RS485)
Communication time-out action

(common serial/RS485)※

Frequency point selection

Point #1 setting

Point #1 frequency
 Point #2 setting

Point #2 frequency

Communication rate (RS485)

RS485 communication system
RS485 communication waiting

time
Inter-drive communication

(RS485)
※：No action: No action is taken even if a timeout occurs.
Alarm: An alarm goes off if a timeout occurs. The message "" blinks at the left end of the
control panel.
Tripping: The inverter trips if a timeout occurs. The message "" blinks on the control panel.
Note) Changes to the parameters , , ,  do not take effect until the
power is turned off and
Adjustment range
∼
Adjustment range
∼
Function
: No parity, : Even parity,
: Odd parity
∼
: OFF, ∼ [s]









: invalid
: Common serial
: RS485
: Communications add-on cassette
∼ [%]
∼ [Hz]
∼ [%]
∼ [Hz]
: 1200 [bps]
: 2400 [bps]
: 4800 [bps]
: 9600 [bps]
: 19200 [bps]
: 38400 [bps]
: 2-line system, 1: 4-line system
: Norm, ∼ [s]
0: Normal communications
(slave operation)
1: Master (frequency reference)
2: Master (output frequency)
3: Master (torque reference)
4: Master (output torque)
then on again.
F-75
Default setting
(Terminal block enabled)
Default setting
(RR)
Adjustment range
RS485 Common serial
No action No action
Alarm No action
Trip No action
No action
Alarm
Trip
No action
Alarm
Trip
option
Setting
(RS485)
Setting
(RS485)
Default setting



Alarm

Alarm
Alarm
Trip
Trip
Trip








