Before Using Your Glass Washer; Using Your Glass Washer - Galaxy Equipment 177GLXYGW User Manual

Before Using Your Glass Washer

Before using your glass washer, please follow these simple instructions.
Failing to do so may cause injury to the user and damage the machine.
1 . Install the machine on a flat surface of a sink and make sure the machine is upright and stable .
2 . Assemble the brushes and check that they are securely in place .
3 . Pour water into the sink and observe that the water level does not exceed the water line mark on
the exterior tube .
4 . Add some detergent for washing .
5 . Plug the power cord in correctly .
WARNING: Do not overfill the sinks/tanks or fully submerse the glass washer motor .
WARNING: Plug the unit into grounded outlets only that match the unit's voltage and frequency
listed on the motor . Outlet must be UL/CSA and G .F .C .I .
WARNING: Check the electric cord and plug to make sure it is clean and dry before using .
Keep the power cord away from the brushes and water . Never use the machine if the
power cord is cracked or damaged .
WARNING: The SWITCH must NOT contact the water, keep it dry .
CAUTION: Check and make sure the brushes are securely in place before turning on the machine .
CAUTION: Do NOT use the machine for any other purpose than its intended design .

Using Your Glass Washer

To start the glass washer, plug in the power cord and switch on the machine. When the
brushes start to spin, put the glass on top of the brush to wash. It is recommended to wash
one glass at a time for the best results.
WARNING: Do not operate the machine out of water .
WARNING: Keep the machine upright . Do not use it if it is lying down .
WARNING: Motor may get hot during and after operation; turn it off when it's not in use .
User Manual
- 5 -