Table of Contents
Advertisement
HUAWEI USG6000E Series Quick Start
2.10 USG6680E
Device and Auxiliary Materials
Figure 2-19 Appearance and auxiliary materials of the USG6680E
Cable Connection
Connect cables according to
not provide a power switch, it starts up immediately after receiving power. When
the SYS indicator on the frontpanel is blinking (once every two seconds), the
device is running and ready for configuration.
Issue 02 (2022-08-22)
NO TE
● By default, 40GE optical interfaces 40GE0/0/2 and 40GE0/0/3 are unavailable. To use
them, run the set device port-config-mode 40g-port enable
command to enable them. However, after that, 10GE optical interfaces numbered
XGE0/0/20 to XGE0/0/27 become unavailable.
● The power cable varies according to the delivery country.
Copyright © Huawei Technologies Co., Ltd.
2 Device Introduction and Cable Connection
Figure 2-20
and power on the device. As device does
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the USG6000E Series and is the answer not in the manual?
Questions and answers