Setting Transmission Limits Per Minute - Leixen VV-898 User Manual

neither receive nor transmit until the correct RX/TX
Enable code is received. If you attempt to transmit
while RX/TX Inhibit is in force, the transceiver will
not indicate transmission, and it will produce an error
tone.
RX inhibit and RXTX inhibit And Reactivate
Codes: These codes are up to 15 characters long,
using 0-9, A-D, * and #.
To activate RX Inhibit or RX/TX Inhibit, use the
programming software to enable the appropriate
settings and assign the appropriate Inhibit and
Reactivate codes. You can then send the Inhibit or
Activate codes using another transceiver that has
DTMF capability.
Note: If "Activation Enable" hasn't been checked, the
transceiver cannot be activated over the air with a reactivation
code. In this case, it can only be reactivated through the
programming software.

Setting Transmission Limits Per Minute

To prevent users from transmitting too often and
potentially disrupting communications, you can limit
the number of transmissions allowed during one
minute period. Set this from 0 (No limit) to 255 in the
programming software. If a limit is set and that limit
is exceeded, the transmitter will issue an error tone
and will not transmit until the timer resets.
52