Attaching The Catcher Bag - Craftsman 247.77763 Owner's Manual

Flange Nuts
Weld
Hex Nuts &
Hex Bolts & Bell Washers
Saddle Washers
Figure 6
• Place the chipper chute over the weld studs
keeping the slottedside towards the bottom.
Loosely secure with the three hex nuts and bell •
washers that were removed earlier. Do not fully
tighten the hex nuts at this point in the assembly.
See Figure 7.
Support'_ ! Chipper ..
Bracket \\ II 1_ Chute
_ Flange
.uts
\ _-_ _" __./_'_ _/_J_l-lexNuts&
"_._ v _lOt / _/ BellWashers
Figure 7
• Align the supportbracket with the holes in the
rightside of the upper and lower handles where
the hex boltswere just removed. Push up
slightlyon the chipper chute in order to better
align the holes in the supportbracket with the
holes in the handles.
• Replace the hex bolts,saddle washers and
flange nuts.to affixthe support bracket to the
handle assemblies. See Figure 7.
• Follow by tighteningall hardware-se_-urelyfirst
on the chipper chute, then on the support
bracket, and finally on the handle.
Attaching the Catcher Bag
• Place the catcher bag inside of handle
assembly, Slip the opening on the bag over the
discharge chute, making certain it is over the rib
on the dischargechute.
Place the four straps on the top of the bag over
the upper handle, hooking them on the studs.
Squeeze the clamp on the drawstring and pull
the drawstringtight. Release the clamp. See
Figure 8,
Discharge Studs
Chute
Rib
Catcher Bag
/
Drawstring Strap
Figure 8
7