Craftsman 315.110990 Operator's Manual

ICRRFTSMRN'I
18.0 Volt
C. R DLES_S.WORKLIGHT
Part No. 975815. -003
Use only with Craftsman battery pack
and charger (both sold separately)
Extra bulb included
_1= CAUTION: Read
Operating Instructions t:
product.
READ ALL INSTRUCTIONS
Safety Rules and
• KNOW YOUR WORKLIGHT. Read owner's
manual carefully. Learn its applications and
limitations as well as the specific potential
hazards related to this light.
• USE ONLY BATTERY PACK PART NUMBER
975284-001 WITH YOUR WORKLIGHT. Any
attempt to use another battery pack will cause
damage to your light and could possibly explode,
cause a fire, or personal injury.
• REMOVE BATTERY PACK FROM
WORKLIGHT BEFORE REPLACING BULB OR
PERFORMING ANY ROUTINE MAINTENANCE
OR CLEANING.
• DO NOT DISASSEMBLE YOUR LIGHT.
• DO NOT PLACE WORKLIGHT OR BATTERY
PACK NEAR FIRE OR HEAT. They may ex-
plode. Also, DO NOT dispose of a worn out
battery pack by incinerating.
• DO NOT STORE YOUR WORKLIGHT IN A
DAMP OR WET LOCATION. ALSO, DO NOT
STORE IN LOCATIONS WHERE THE TEM-
PERATURE MAY REACH OR EXCEED 120°F.
For example, outside sheds, vehicles, or metal
buildings in the summer.
• DO NOT PERMIT CHILDREN TO USE
WORKLIGHT UNSUPERVISED. It is not a toy.
The temperature of the bulb can become hot
after being on for an extended period of time.
This hot temperature may cause burn injury if
touched.
KEEP WORK AREA CLEAN. Cluttered areas
and benches invite accidents.
AVOID DANGEROUS ENVIRONMENT.
KEEP LIGHT DRY, CLEAN, AND FREE FROM
OIL AND GREASE. Always use a clean cloth
when cleaning. Never use brake fluids, gasoline,
petroleum-based products or any strong solvent
to clean your light.
STAY ALERT. Watch what you are doing and
use common sense. Do not rush.
CHECK DAMAGED PARTS. Before further use
of this light, a part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. A part
that is damaged should be properly repaired or
replaced.
IMPORTANT SAFETY RULES FOR BA'I-I'ERY
TOOLS
USE ONLY THE CHARGER RECOMMENDED
FOR USE WITH YOUR WORKLIGHT. Do not
substitute any other charger. Use of another
charger could cause batteries to explode causing
possible serious injury.
• Your battery tool should be charged in a location
where the temperature is more than 50°F but
less than IO0°F.
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with
soap and water, then neutralize with lemon juice
or vinegar. If liquid gets in your eyes, flush them
with clean water for at least 10 minutes, then
seek immediate medical attention.
• WHEN SERVICING USE ONLY IDENTICAL
CRAFTSMAN REPLACEMENT PARTS.
IMPORTANT SAFETY INSTRUCTIONS FOR
CHARGER
• Before using battery charger, read all instructions
and cautionary markings in this manual, on
battery charger, and product using battery charger.
,_, WARNING: To reduce the risk of injury, charge
only nickel-cadmium type rechargeable batteries.
Other types of batteries may burst causing
personal injury and damage.