Advertisement
@ INTRODUCTION
Congratulations!
it in a safe place for later reference.
€ MAIN FEATURES
* 2-спаппе! 2-mode Configuration
From the input jacks to speakers, the VR4000 and VR6000 feature an
independent 2-channel circuit configuration which allows the "A" and
"B" channels to function essentially as two separate amplifiers. In addi-
tion to this you have a choice of "A ог B" or "А and B" modes, selected
by a single switch. In the "A or B" mode the two channels function
separately and independent settings can be made for each, while in the
"A and B" mode the channels are "coupled" and operate together.
ж Compatible with Stereo Sources
Guitars with stereo outputs or separate guitars can be connected to the
amplifier's two channels, and each channel can be independently set to
create the desired sound.
* Separate Channel Control Configurations
The "A" and "B" channels have slightly different control configurations:
the "A" channel has a single volume control allowing production of
clean, pure tones, while the "B" channel has both gain and volume con-
trols for a broad range of distortion effects. Both channels feature
three-band tone controls as well as "bright" and "fat" switches for ex-
tended tonal versatility.
ж Parametric Equalizers
Both channels feature versatile parametric equalizers that let you pre-
cisely pinpoint and boost or cut specific frequencies for uncompromis-
ing response control accuracy. The VR6000 offers extra control with
twin parametric equalizers.
Ж Reverb & Stereo Chorus
Top-quality reverb and stereo chorus effects are built-in. In particular,
the stereo chorus effect employs both normal and reverse-phase cho-
rus signals to produce an exceptionally fine chorus sound.
* Newly-developed Large-diameter Speakers
These speakers were developed specially for the VR4000 and VR6000,
featuring aluminum center-caps and large-diameter cones they deliver
powerful, clean sound from the heaviest lows to the most sparkling
highs.
* Dual Effect Loóps
The VR4000 and VR6000 have dual effect loops for compatibility with a
wide range of external signal processing equipment. The first loop is
located prior to the chorus circuit and is compatible with 1-in/2-out type
effect units. The second is located after the chorus circuit and offers 2-
in/2-out compatibility.
* Stereo Outputs & Stereo Headphones Jack
Both the line output jacks and headphone output jack offer full stereo
output.
* Footswitch Jack
An optional VFC-3 Footswitch connected to this jack can be used to
switch between the "A" and "B" channels in the "A or B" mode, switch
the reverb effect ON or OFF, and switch the chorus effect ON or OFF.
Advertisement
