TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" Wrenches
•
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify
using the illustrations on page 3.
•
Insert each side of the axle of the impeller assembly
into the frame tube. See figure 1.
•
Insert the two hex flange bearings (I) into the frame
tube. See figure 1.
I
FIGURE 1
•
Attach the hopper to the frame tube using two 1/4" x
1-1/2" hex bolts (A), 1/4" washers (G), and 1/4" nylock
nuts (D) as shown in figure 2. Tighten.
•
Insert an 1/8" hair cotter pin (E) into the hole at the
top of the impeller. See figure 2.
E
A
H
D
FIGURE 2
ASSEMBLY
I
A
H
D
•
Slide a spacer (J) over the right side of the axle. See
figure 3.
•
Attach the drive wheel (9) to the right (indented) side
of the axle. Secure the wheel in place with a hub cap
(K). See figure 3.
J
M
9
K
FIGURE 3
•
Slide a spacer (J) over the left side of the axle. See
figure 4.
•
Attach the wheel (10) to the left side of the axle.
Secure the wheel in place with a hub cap (K). See
figure 4.
FIGURE 4
4
J
10
N
K