Service And Adjustments; Storage - Craftsman SNOW BLADE 486.24441 Operator's Manual

To Adjust Blade Spring
• The tension of the blade adjust spring may be altered
to per mit the blade to tilt forward to bypass solid
ob struc tions. To change the spring tension, adjust the
nuts at upper end of the spring bolt. Stand ing in front
of blade, turn the nuts coun ter clock wise to relieve
tension and clockwise to increase tension. Refer to
fi gure 17 on page 9.
To Adjust Blade Shoes
• The blade shoes at the ends of blade may be raised
for close work on smooth surfaces or lowered to raise
the blade to work on rough or uneven areas. Make
sure both shoes are set evenly and that the nuts are
tight ened securely.
BLADE SHOE
FIGURE 26
Recommendations When Storing
• When the snow blade is not being used, remove all
dirt and rust and touch up with paint.
• Touch up bare metal with paint or apply a light coat of
grease or rust preventive.
• Lubricate all pivot points and all points shown in fi gure
25, page 12 in the maintenance section.
• Store in a dry area, protected from weather.
To Remove Blade From Tractor
• Lower the blade to the ground with the blade in the
center (straight ahead) position.
• Remove the hairpin cotter which fastens the blade
pivot rod to the blade pivot shaft. See fi gure 22 on
page 10.

SERVICE AND ADJUSTMENTS

STORAGE

To Adjust the Blade Pivot Lock Mechanism
• If the blade will not unlock and pivot, the angle lock
bars are not disengaging from the slots in the pivot
plate. To correct, adjust the 5/16" hex jam nuts to draw
the end of the control cable back towards the cable
mount bracket. The less the threaded end of the cable
extends through the bracket, the more the angle lock
bars can retract to dis en gage from the slots in the
pivot plate.
CABLE MOUNT BRACKET
5/16" HEX
JAM NUT
FIGURE 27
• Remove the hairpin cotter which fastens the lift handle
rod to the lift link pin. See fi gure 19, page 10.
• Remove the hairpin cotter from the channel pivot pin
and remove the pivot pin from the channel assembly.
See fi gure 18 on page 9.
• Remove the blade, the channel assembly and the
lift handle assembly from the tractor. The brackets
assembled to the tractor frame may be left in place.
• To remove the brackets assembled to the tractor
frame (side plates and pivot support brackets) refer to
the fi gures appropriate for your tractor on pages 5 - 7.
• If the side plates are removed from the tractor frame,
be sure to reassemble any bolts that were removed
from the frame. Refer to fi gures 1 and 3 on page 5.
13
CONTROL
CABLE
5/16" HEX
JAM NUT