Table of Contents
Advertisement
Available languages
Available languages
www.domo-elektro.be
MAKING THE BED
•
Place the electric blanket on the mattress, at the foot end of the bed. The control
unit needs to be placed at the head of the bed. Make sure that the heated blanket is
not placed under a pillow or hangs over the edge of the bed.
•
The electric lead and the control unit must remain outside the bed and may not be
left in the vicinity of any source of heat, such as a radiator or lamp.
PARTS
1. Warning label and type plate
2. Blanket connection
3. Lead connection
4. Electric lead
5. Electronic control unit
CONTROL
1. On/off switch
2. Start/stop button
3. Function button (mode)
4. "+" and "-" button
5. Timer button
6. Preheat button
INSTRUCTIONS FOR USE
•
Plug the electrical connector into the blanket's
electrical fixture.
•
Plug the device into the socket.
•
Adjust the regulator at the side of the control
unit to the "1" position.
•
Press the "mode" button to set the temperature
of the blanket.
•
Press the "+" or "-" buttons. You can make a selection from "1" to "8" for the
different temperature settings. "1" is the lowest temperature and "8" is the highest
temperature. Select "foot" if you wish to heat only the foot end of the blanket.
ATTENTION: Temperature selection "8" is the highest temperature setting. This
setting is used only to quickly preheat the blanket. After 30 minutes this setting
will automatically set itself to position "3".
•
Press the "timer" button to adjust the length of time you wish to heat the blanket.
Use the "+" and "-" button to set the time from 1 min to 12 hours.
•
Press the "preheat" button to preset the time for start heating. Use the "+" and
"-" button to set the length of time you wish to start preheat, between 1 minute to
19:59 h.
•
We recommend preheating the unit at position "7" or "8". This setting cannot be
2
1
4
2
1
3
31
DO604ED
4
5
3
6
5
Advertisement
Table of Contents
