Tools Required For Assembly - Craftsman 536.88123 Instructions Manual

Parts packed separately in carton (not shown full size)
2 - Ignition Keys
(Attached to engine in plastic bag)
Z_ CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower,
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton and plastic ties
2 - 1/2 inch wrenches (or adjustable
wrenches)
2- 9/16 inch wrenches (or adjustable
wrenches)
1 - Pliers (to spread cotter pin)
1- Screwdriver
1 - Air pressure gauge
1 - Measuring tape or ruler
The figure below shows the snow thrower in
the shipping carton.
,i
The figure below shows the snow throwe_
completely assembled.
I
References to the right or teft hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit,
Auger Drive Lever
Speed
Lever
Cable
Headlight
Chute
Deflector
Height
Adjust