Starting The Usb Sleep And Charge Utility; Enabling Usb Sleep And Charge - Toshiba NB205-N311 User Manual

■
The USB Sleep and Charge function only works for compatible ports.
This function is disabled as a default setting.
■
When the USB Sleep and Charge function is set to [Enabled], USB
bus power (DC5V) will be supplied to compatible ports even when the
power of the computer is turned OFF.
USB bus power (DC5V) is similarly supplied to the external devices
which are connected to the compatible ports. However, some external
devices cannot be charged solely by supplying USB bus power (DC5V).
As for the specifications of the external devices, please contact the
device manufacturer or check the specifications of the external
devices thoroughly before use.
■
Using the USB sleep and charge function to charge external devices
will take longer than charging the devices with their own chargers.
■
If external devices are connected to compatible ports when the AC
adaptor is not connected to the computer, the battery of the computer
will be depleted even when the power of the computer is turned OFF.
As such, we recommend that you connect the AC adaptor to the
computer when using the USB sleep and charge function.
■
External devices connected to the USB bus power (DC5V) function
that interfaces with the power ON/OFF of the computer may always be
in an operational state.
■
When there is a current overflow of the external devices connected to
the compatible ports, USB bus power (DC5V) supply may be stopped
for safety reasons.
Metal paper clips or hair pins/clips will generate heat if they come into
contact with USB ports. Do not allow USB ports to come into contact with
metal products, for example when carrying the computer in your bag.

Starting the USB Sleep and Charge Utility

To start the utility, click Start
USB Sleep and Charge.
You can also configure Mode1, Mode2, Mode3, Mode4 and disable settings
for the USB sleep and charge function within the BIOS Setup menu. Please
refer to
BIOS Setup Menu.

Enabling USB Sleep and Charge

This utility can be used to enable and disable the USB Sleep and Charge
function.
Check the "USB Sleep and Charge" check box. In the default state this
function is disabled.
User's Manual
Accessing BIOS Setup Menu
All Programs TOSHIBA
in Chapter 7 for details on starting the
Operating Basics
Utilities
4-3