Custom Setting 19: Flash Mode
To choose the ﬂ ash mode for the built-in Speed-
light, highlight Flash mode in the detailed CSM
135) and press the multi selector to the
right. Press the multi selector up or down to high-
light an option, then press to the right to make a
Output of built-in Speedlight is adjusted automatically in response to
Menu at right will be displayed. Highlight set-
ting between Full (full power) and 1/16 (
full power) and press multi selector to right to
return to CSM menu. When mode dial is set to
P, S, A, or M, ﬂ ash will ﬁ re at chosen fraction
of full power whenever built-in Speedlight is
raised (at full power, built-in Speedlight has GN
[m / ft] of 17/56 [ISO 200] or 12/39 [ISO 100]).
panel and viewﬁ nder. No monitor preﬂ ash is emitted, allowing built-in
Speedlight to function as master ﬂ ash for optional slave ﬂ ash units.
Choose this option to allow camera to con-
trol ﬂ ash level when one or more SB-800
or SB-600 Speedlights are used for wireless
ﬂ ash photography in P, S, A, or M mode.
Menu at right will be displayed; choose TTL
(i-TTL ﬂ ash control, available only with CPU
lens), AA (Auto Aperture, available only
when CPU lens is used with SB-800), or M
(Manual). Selecting M displays menu shown
at right; press multi selector up or down to
choose output level for wireless ﬂ ash unit
from values between Full (full power) and
lector to right to return to CSM menu.
* If Commander mode is selected, will not
be displayed in ﬂ ash sync mode icon when
built-in Speedlight is raised.
of full power). Press multi se-
19 Flash mode
icons blink in control
19 Commander mode