Table of Contents
Advertisement
OPERATION
TO START
ENGINE
(See
Fig. 8)
When starting the engine for the first time or if the engine
has run out of fuel, it will take extra cranking time to move
fuel from the tank to the engine.
•
Sit on seat in operating position, depress clutch/brake
pedal and set parking brake.
•
Place gear shift lever in neutral (N) position.
•
Move attachment clutch to =DISENGAGED" position.
•
Move throttle control to fast position
•
Pull choke control out for a cold engine start attempt.
For a warm engine start attempt the choke control may
not be needed.
Note: Before starting, read the warm and cold starting
procedures below.
•
Insert key intoignitionand turn keyclockwise to "START"
position and release key as soon as engine starts. Do
not run starter continuously for more than fifteen sec-
onds per minute. If the engine does not start after
several attempts, push choke control in, wait a few
minutes and try again. If engine stilldoes not start, pull
the choke control out and retry.
WARM WEATHER STARTING (50 ° F and above)
•
When engine starts, slowly push choke control in until
the engine begins to run smoothly. If the engine starts
to run roughly, pull the choke control out slightly for a
few seconds and then continue to push the control in
slowly.
•
The attachments and ground drive can now be used. If
the engine does not accept the load, restart the engine
and allow it to warm up for one minute using the choke
as described above.
COLD WEATHER STARTING (50 ° F and below)
•
When engine starts, slowly push choke control in until
the engine begins to run smoothly. Continue to push
the choke control in small steps allowing the engine to
accept small changes in speed and load, until the
choke control is fully in. If the engine starts to run
roughly, pull the choke control out slightly for a few
seconds
and then continue to push the control in
slowly. This may require an engine warm-up period
from several seconds to several minutes, depending
on the temperature.
•
The attachments can be used during the engine warm-
up period and may require the choke control be pulled
out slightly.
NOTE: If at a high altitude (above 3000 feet) or in cold
temperatures (below 32 F) the carburetor fuel mixture may
need to be adjusted for best engine performance.
See "TO
ADJUST CARBURETOR"
in the Service and Adjustments
section of this manual.
MOWING
TIPS
•
Tire chains cannot be used when the mower housing is
attached to tractor.
•
Mower should be properly leveled for best mowing
performance.
See "TO LEVEL MOWER HOUSING" in
• the Service and Adjustments
section of this manual.
•
The left hand side of mower should be used for trim-
ming.
•
Drive so that clippings are discharged onto the area
that has been cut. Have the cut area to the right of the
tractor.
This will result in a more even distribution of
clippings and more uniform cutting.
•
When mowing large areas, start by tuming to the right
so that clippings will discharge
away from shrubs,
fences, driveways, etc. After one ortwo rounds, mow
in the opposite direction making left hand tums until
finished (See Fig. 10 ).
•
If grass is extremely tall, it should be mowed twice to
reduce load and possible fire hazard from dded clip-
dPin_ls. Make first cut relatively high; the second to the
eslred height.
•
Do not mow grass when it is wet. Wet grass will plug
mower and leave undesirable clumps. Allow grass to
dry before mowing.
•
Always operate engine at full throttle when mowing to
assure better mowing performance and proper dis-
charge of material. Regulate ground speed by select-
ing a low enough gear to give the mower cutting
performance as well as the quality of cut desired.
•
When operating attachments, select a ground speed
that will suit the terrain and give best performance of
the attachment being used.
FIG. 10
MULCHING
MOWING
TIPS
IMPORTANT:
FOR BEST
PERFORMANCE,
KEEP
MOWER HOUSING FREE OF BUILT-UP GRASS AND
TRASH.
CLEAN AFTER EACH USE.
•
The special mulching blade will recut the grass clip-
pings many times and reduce them in size so that as
they fall onto the lawn they will disperse into the grass
and not be noticed.
Also, the mulched grass will
biodegrade quickly to provide nutrients for the lawn.
Always mulch with your highest engine (blade) speed
as this will provide the best recutting action of the
blades.
•
Avoid cutting your lawn when it iswet. Wet grass tends
to form clumps and interferes with the mulching action.
The best time to mow your lawn is the early afternoon.
At this time the grass has dded and the newly cut area
will not be exposed to the direct sun.
•
For best results, adjust the mowercutting
height so that
the mower cuts off only the top one-third of the grass
blades (See Fig. 11). For extremely heavy mulching,
reduce your width of cut and mow slowly.
Certain types of grass and grass conditions may re-
quire that an area be mulched a second time to com-
pletely hide the clippings. When doing a second cut,
mow across or perpendicular to the first cut path.
•
Change your cutting pattern from week to week. Mow
north to south one week then change to east to west the
next week. This will help prevent matting and graining
of the lawn.
MAX 1/3
14
FIG. 11
Hide quick links:
Advertisement
Table of Contents
