Whirlpool FT3905 Installation Manual page 14

Cleanin ng and Mainte
If the dust or dirt accumulated on
performance e of air‐out would be aff

Always u unplug the fan before cl

Unplug t the unit and wait until t

Use a da amp cloth to clean the s

To clean n the wind wheel, take o
Disassem mbling & Installation ins
water. D Do not use any chemical

After cle eaning, make sure the p
before c connecting to the power

If the fan n will not be used for a l
children . Do not store the applia
Disassembli ing & Installation Instru
1. Turn off f the fan and unplug the
2. Push th e back button, the rear
3. Rotate t the bottom nut clockwis
upward d. (See Pic 4)
4. Clean a nd wind wheel carefully
5. Put the wind wheel back to the
wheel. T Then putting back the re
Pic c 3
enance:
n the front grid cover
fected, it is suggested to
eaning, doing maintena
he fan stop running befo
urface of the fan.
out and install the wind w
structions for wind whee
s or other solvents to cl
roduct, wind wheel and
r supply.
long time, store it in a co
ance in hot place and un
uctions for wind wheel:
e machine.
grill will loosen, and tak
se to loosen the nut and
y and dried it up comple
e machine, rotate the bo
ear grill and the fan can
Pic 4
and wind wheel of th
o clean the fan once per
ance work or moving the
ore cleaning.
wheel in a right way acc
el. You can clean the win
ean the wind wheel.
the other parts must dr
ool, dry, safety place an
nder sunshine.
ke it down. (See Pic 3)
d then take out the wind
tely before use.
ottom nut anticlockwise
be use normally. (See P
he fan, the
r month.
e machine.
cording to below
nd wheel in the
ry completely
d far away from
d wheel sidling‐
to tighten the wind
Pic 5)
Pic 5