Selection Switch Settings - Texas Instruments TI-5045SV User Manual

POWER
OFF ON PRT IC GT
Set the POWER, ROUND, DECIMAL and TAX switches as required.
Note: The TAX switch is spring-loaded to return to CALC when it is moved to SET and released.
The switch settings are summarized in the following table:
SWITCH SETTING
POWER ON
PRT
IC
GT
ROUND
5/4
Ex.
Setup:
Press
220 '
6 3
DECIMAL +
F
0 2 3 4

SELECTION SWITCH SETTINGS

ROUND
5/4
FUNCTION
No printout is provided; however, the display can be printed by pressing
.
The printer provides a printout of your calculations but does not count them.
The printer is on and an item count of additions and subtractions to or from
the register is printed when sub-totaled or totaled.
The GT position controls whether or not the totals from the independent add
register are accumulated in the grand total register.
Rounds the result of a calculation to the selected number of decimal places.
Truncates the result to the selected number of decimal places.
Rounds the result up or down according to its value. For example, when the
DECIMAL switch is set to 2, the result is rounded up if the third decimal
position is 5 or more and rounded down if it is 4 or less.
Rounds the result up to the selected number of decimal places.
220 P 6
PRINTER: PRT, ROUND: :
DECIMAL: 2, TAX: CALC
Display
2
0.
220.
36.66
Add mode: All results are given with two decimal places. For addition and
subtraction only, a decimal point is automatically placed to the left of the last
two digits entered, unless the number already includes a decimal point.
Floating mode: Any results are displayed and printed with the maximum
number of decimal places.
Fixed decimal mode: Sets the number of decimals to 0, 2, 3, or 4.
DECIMAL
+ F 0
Ex.
Setup:
Printout Press
0 ¦ C
220 ¦ P 220 '
6 ¦ 6 3
=
36 ¦ 66 …
2
3
2 4
220 P 6
PRINTER: PRT, ROUND: 5/4
DECIMAL: 2, TAX: CALC
Display
2
0.
220.
36.67
TAX
SET CALC
Printout
0 ¦ C
220 ¦ P
6 ¦
=
36 ¦ 67 …