Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged parts.
If any parts are missing or damaged, do not attempt to assemble or use the product. Please contact customer service for replacement.
CARTON CONTENTS:
Part# Description
01. Top fountain
02.
Pedestal
03.
Pump
04. Basin
TOOLS REQUIRED FOR ASSEMBLY:
No tools required
ASSEMBLY INSTRUCTIONS:
1.
Unpack the contents of the box and check to make sure that all items
are accounted for and in good condition.
2.
Select a flat, level surface for the assembly and final location of your
fountain.
3.
Place the top fountain on the floor on its side. Attach the pedestal to the
top fountain with the plastic wedge plates on the underside of the top
fountain and the top of the pedestal. Align the tabs on the wedge plates,
connect, and rotate clockwise to lock them together. (Fig.1)
4.
Place the basin on a flat, level surface. Insert the water supply tube
from the underside of the top fountain into the pump outlet. Align the
notch of pedestal with the resin wedge in the basin and then place the
top fountain and pedestal into the basin over the resin wedges. (Note:
draw the pump power cord out from the cord slot of the pedestal.)(Fig.2)
5.
Add clean water into the basin. The water level should be approximately 20mm below than the top edge of the basin. (Fig 3)
6.
Connect the pump to a GFCI outlet and the product will begin to function as intended. Gently sweep across the water surface to achieve even water flow
across the surface. (Fig 3)
7.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after the initial setup of your fountain. It is
highly recommended that this fountain be placed in an area that will not be damaged should the area come in contact with liquid.
8.
Do not leave your fountain running for extended periods of time or when no one is present to observe the performance.
9.
Check the area around your fountain on a regular basis to ensure that there is no leakage.
NOTE:
The diagrams shown are for illustrative purposes only and are not to scale
Vendor Item # FA0844AA (084 09 3148)
Urn Fountain
Questions, Problems, Missing Parts? Before returning to your retailer,
PLEASE CALL CUSTOMER SERVICE at (866) 728-6187
9am – 5pm EST, Mon – Fri or e-mail customerservice@srg-usa.com.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Quantity
1
1
1
1
Need help?
Do you have a question about the FA0844AA and is the answer not in the manual?
Questions and answers