Summary of Contents for Denver Electronics SCO-65100
Page 1
Original Instruction SCO-65100 facebook.com/denverelectronics Before operating this vehicle, read all the instructions for safe assembly and operations. User’s manual can guide you through the functions and usage of E-scooter. Before using this E-scooter, familiarize yourself with how to operate, so that you can keep the E-Scooter in the best condition possible.
Folding steps 1. Unfolding: 1) Stand the E-scooter on its wheels, press the unlock clasp. 2) Raise the handle slowly. 3) The E-scooter is unfolded as soon as you hear the rod click into place. 2. Folding Hold the clasp and pull it outward Press the front tube of E-scooter downward (Attention: The limit position must be put right.) The rod clicks audibly into place.
4) Dual action safety knob Fold-Unfold Position Press the red button to fold or unfold the e-scooter. Rotate the safety knob to position “Folding” on left or right, you can press the red button to fold your e-scooter. Rotate the safety knob to “RIDING” position, you can start your driving. The knob must be set to RIDING when riding for safety issue to prevent unintended folding the e- scooter.
Intended Use The e-scooter is neither a means of transport nor sports equipment, rather a device that the operator can ride relaxed. The E-scooter for domestic use only and only by a person aged at least 14 with a maximum weight of 100 kg.
Page 8
As a result, the brake pad constantly touches the wheel and the motor temperature increases due to the additional resistance. The rear tire can also get loose if the brake is in constant braking position. Avoid constant braking. As a result, the tires will not only wear off, but also become hot. This will soften the rubber and it will no longer have the same grip on the road as usual.
Maintenance Storage and cleaning If your E-scooter gets dirty, please clean it with a damp cloth. (you can use a stiff brush first to get the worst dirt off and then use a cloth afterwards to clean it.). It is also possible to use a little toothpaste if the dirt is stuck.
Page 10
It is forbidden to disassemble battery package. This is only to be handled by official service repair centers and professionals. Maintaining bearings The E-scooter has sealed and dustproof bearings so that no lubrication is required. Check the bearings for wear at regular intervals to avoid unsafe riding. Do not jump on and off and do not apply excessive force otherwise to avoid damage to the bearings.
Instrument menu For better operation, please read the instructions carefully. Speed up Button Power Button Speed down Button Accelerator Button Electric Brake Button 8.1 Button Power Button, ▲ Speed up Button and ▼ Speed down There are three buttons in the display, Button.
gear). Deceleration: Gently press the deceleration dial to slow down. The deeper the press, the greater the deceleration (the deceleration is relevant to the formation of the press, and pushing too hard can not increase the braking force and may cause damage to the brake dial). Total mileage clearance: press ▲...
11. E-scooter safe parking Once you have stopped the E-scooter, get off it and press the side stand down with your right foot to support the E-scooter. The side stand is located on the left-hand side of the E-scooter below the foot board.
Page 15
acceleration and braking. 13.5. Safe riding This chapter focuses on safety, experience, and warnings. Before operating the vehicle, please read all installation and operating instructions carefully. Familiarize yourself with the vehicle before you use it so that you can keep the E-scooter in sound condition.
Page 16
• When charging at lower or higher temperatures, there is a risk that the battery performance will be reduced; therefore, there is a potential risk of injuries and material damage. • Store and charge the device in an open, dry area away from combustible materials. •...
Page 17
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S Electric and electronic equipment and included batteries contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment and batteries) is not handled correctly.
Page 18
Regarding Battery charging SCO-65100 Important – Please read! Dear customer. We hope you get a lot of joy out of your new E-scooter. The battery type in these kinds of E-scooters are not fully charged from production line. And when left unused they can slowly discharge by themselves.
Need help?
Do you have a question about the SCO-65100 and is the answer not in the manual?
Questions and answers