Unassembled Parts; Assembly/Pre-Operation - Craftsman 917.28907 Owner's Manual

Steering Wheel
/ \
J
i
Steering
Wheel insert
Steering
Wheel
(1) Large
Fiat Washer
(1) Hex Bolt
//
I I _ , '%z j Steering
- /
Steering Wheel "_<- .... Extension
Adapter Steering Boot Shaft
(1) Lock
Washer
Seat
(1) Washer
\
(1) Seat _ .......... jJ (1) Hex Bolt
Slope Sheet
For FutureUse
Key(s)
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools as
necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 5/16" wrench Utility knife
(2) 7/16" wrenches Tire pressure gauge
(2) 1/2" wrenches Pliers
(1) 9/16" wrench
When right or left hand is mentioned in this
manual, it meanswhen you arein the operating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts and
parts boxes from carton.
2. Cut along dashed lines on all four panels
of carton. Remove end panels and lay
side panels flat.
3. Check for any additional loose parts or
cartons and remove.