Preparing The Cash Register; Installing Paper Rolls - Sharp XE-A505 Instruction Manual

Hide thumbs Also See for XE-A505:
Table of Contents

Advertisement

The cash register has a built-in memory protection circuit which is operated by rechargeable
batteries. Since the rechargeable batteries have been discharged, please charge the batteries for
one or two days before using the cash register for the first time. To charge the batteries, set the
mode switch to a position other than "OFF" with the power cord plugged into the AC outlet.
Unless the batteries have been charged, all of the programmed data and sales data are not saved.
If you press a key by mistake, an error message such as "HEAD UP" or "PAPER EMPTY" may be
displayed. Press the
4

Preparing the cash register

To make the cash register ready for operation, remove the
retainer and set the print head release lever in print position.
1.
Push the printer cover forward and detach it.
2.
Remove the white retainer at the position shown at the right. Please
keep this retainer for future use when transferring the cash register.
3.
Move the print head release lever to the printing position as
illustrated at the right.
5

Installing paper rolls

Precaution: The paper cutter is mounted on the printer (receipt side). Take caution when
The register can print receipts and journals. For the printer, you must install the paper rolls (receipt and journal
paper rolls) provided with the register.
Install the paper rolls according to the procedure shown below with the power cord connected and the mode
switch set to the PGM position:
How to cut a paper roll and set it in the paper roll cradle:
Correct
When setting a new paper roll in the paper roll cradle, be sure to cut the paper end behind the
taped (or pasted) point in advance.
1.
Cut off approximately one revolution of each paper roll. Make sure each paper end is cut as illustrated
above.
2.
Set a paper roll in the paper roll cradle of the receipt side as illustrated above.
l
key to clear message after installing paper rolls.
installing paper rolls.
Incorrect
To the printer
Correct
Retainer
Print head
release lever
(printing position)
To the printer
Incorrect
9

Advertisement

Chapters

Table of Contents
loading

Table of Contents