Epson ActionNote 4SLC/33 User Manual page 85

ADVANCED CMOS SETUP Options
Option
Typematic Rate
Programming
Typematic Rate
Delay
Typematic Rate
PS/2 Mouse
Support Option
Above 1 MB
Memory Test
Memory Test
Tick Sound
Hit <Del>
Message Display
Hard Disk Type
47 Data Area
Wait For <F1>
If Any Error
System Boot Up
Num Lock
Floppy Drive
Seek At Boot
5-8 Running Setup
Function
Enables or disables programming of the typematic
rate; If enabled, you can change the next two options
on the screen
Sets the delay period between the time you press a
key and the time the character appears on the screen
(in
milliseconds); the higher the number, the longer the
delay; the default is 500 msec, or 1/2 second
Sets the rate at which a character repeats when you
hold down a key; the higher the number, the faster the
repeat rate; the default is 24 characters per second
Enables or disables PS/2-type mouse support for the
EXT KB port; always enable this option when you
connect a pointing device to the EXT KB port
Enables or disables testing of memory above 1MB
during system startup; disabling this option speeds up
the startup process
Enables or disables an audible ticking sound as
memory Is tested during system startup
Enables or disables the message that prompts you to
run the Setup program: if you disable this message,
you will not see Hit <Del>, If you want to run
Setup:you can still start the Setup program by
pressing
Identifies where the hard disk drive parameters table is
stored; it is not necessary to change this setting
Enables or disables the message that prompts you to
press to run Setup when an error occurs
Turns the Num Lock function either On or Off whenever
the system starts up
Enables or disables checking the diskette drive for
COMMAND.COM during system startup; enable this
option if you plan to start the computer from drive A
during the memory test