Replacing The Remote Batteries - PROTRON PLTV-26M User Manual

26/27/32" liquid crystal display
Hide thumbs Also See for PLTV-26M:
Table of Contents

Advertisement

OMPLTV26M_27M_32M.book Page 13 Monday, October 10, 2005 11:44 AM
Button(s)
Note: To use a universal remote with your display, program the remote to control any NEC
television.

Replacing the Remote Batteries

The remote requires two AAA batteries, which are held in a small
enclosure on the rear of the remote.
To replace the batteries:
1. Release the tab and pull the enclosure out of the remote.
2. Remove the old batteries and replace them with the new
batteries. Ensure the batteries are oriented as indicated in the
enclosure.
3. Snap the enclosure back into the remote.
Function
Selects the highlighted item or confirms the current adjustment
These buttons activate and configure Picture-in-Picture, as follows:
• PIP—Selects the PIP mode: Off, Standard PIP, or PBP
1
2
PIP
Note: PIP is only available when the aspect ratio is set to Full
(see ZOOM above).
• SOURCE—On first press, selects the secondary window.
Further presses select the signal source used for the secondary
window.
When the secondary window is selected, it will have a pink
border, and you will be able to change settings for it using the
remote and On-Screen Display.
• POSITION—When PIP is set to Standard PIP mode, adjusts the
position of the secondary PIP window
• SWAP—Swaps the primary and secondary sources
• FREEZE—Freezes the content of the main window
Brings up the V-Chip configuration menu
Cycles through the closed captioning modes: Off, C1–4, and T1–4
13
Using the Remote Control
1
2
PBP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pltv-32mPltv-27m

Table of Contents