Installing The G4/G5 Qip Pin - Spectra Logic T-Series Spectra T120 Supplementary Manual

G4/G5 QIP Upgrade and Encrypted Media Guide

Installing the G4/G5 QIP Pin

1. Remove the bolt extractor from the end of the extender.
2. Set the ratchet to tighten.
3. Attach the deep-well socket to the other end of extender.
4. Insert the G4/G5 QIP pin into the socket, as shown below.
Figure 5
Inserting the pin into the socket.
5. Carefully reach the extractor inside the library and fit the pin into its hole.
6. Use the extender tool to screw in the pin until it is just finger-tight.
7. Carefully remove the tool from the QIP bay.
8. Proceed to Installing the G4/G5 QIP on page 10.
9