Using The Appliance; Controls Panel - Beko Hcp61310I User Manual

Using the appliance

3

3.1 Controls panel

To turn off the lamp, set the lamp switch to "0" position. To turn on the lamp, set the lamp switch to
: Light
"1" position.
On / Off
: Motor To turn off the motor, set the motor switch (
You can run the motor minimum at speed level 1 and maximum at speed level 3 depending on the
cooking vapour intensity.
• The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
• Never use the hood for purposes other than for which it has been designed.
• Never leave high naked flames under the hood when it is in operation.
• Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not
engulf the sides.
• Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.
3.2 Efficient use in terms of energy saving
• When using your appliance, adjust the speed settings according to vapour and odour intensity, in
order to save energy.
• Use low speeds (1-2) under normal conditions, and high speed (3) and boost mode for intense odour
and vapour.
• The hood is equipped with lamps in order to illuminate the cooking area.
• Using them for environmental lighting shall cause unnecessary energy expenditure and insufficient
lighting.
• For your device to consume less energy, run it at a low speed level.
• Your device will reduce energy consumption as it will run more efficiently when you provide sufficient
air intake to it.
• Set your device to the intense suction power level before the formation of steam, in cases where you
know that the dense steam will occur. So, you reduce energy consumption by using your device for a
shorter time as it will have a sufficient air intake.
• Keep the lids of the cookware closed to reduce the steam evolving.
3.3 Operating the Hood
• Hood is equipped with a motor having various speed settings.
• For a better performance, we advise you to use low speeds in normal conditions, and high speeds
when smell and vapors are intensified.
• You can start the hood by pressing the desired speed level key.(1, 2, 3 )
• You can illuminate the cooking area by pressing the light key.
Cooker Hood / User Manual
) to '0' position.
9 / EN