UNPACKING AND CHECKING
CONTENTS (Fig. C)
This Bench Grinder will require a minimal amount of
assembly. A 10mm and 13mm open end wrench is
provided for mounting the Tool Rest Assemblies and
the Spark Arrestor Assemblies.
Remove all of the parts from the shipping box and lay
them on a clean work surface. Compare the items to
Fig. C, verify that all items are accounted for before
discarding the shipping box.
If any parts are missing, do not attempt to plug in the
power cord and turn "ON" the Bench Grinder. The
Bench Grinder can only be turned "ON" after all the
parts have been obtained and installed correctly.
The following items are to be provided in the shipping
B. Quench tray
C. Wheel dresser
D. Eyeshield assembly
E. Left tool rest assembly (not shown)
F. Right tool rest assembly
G. Special Wrench