Craftsman 973.111330 Owner's Manual page 8

SWITCH
See Figure 2,
TO tum your drill ON, depress the switch tdgger. To
turn it OFF, release the switch trigger.
SELECTOR
CENTER PosmoN
(LOCK)
SWITCH
TRIGGER Fig. 2
VARIABLE SPEED
This tool has a vadable speed switch that delivers
higher speed and torque with increased tdgger
pressure. Speed is controlled by the amount of switch
trigger depression.
Note: You might hear a whistling or ringing noise from
the switch during use. DO not be concerned, this is a
normal part of the switch function.
TO INSTALL BATTERY PACK
• Lock switch tdgger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
• Place battery pack in your drill, Align raised rib
inside ddll with groove on battery pack. See
Figure 3,
DE HES
TO RELEASE
BATrlENT PACK Fig. 3
• Make sure the latches on each side of your
battery pack snap in place and battery pack Is
secured in dhll before beginning operation.
_ CAU'rlON: When placing battery pack in your
ddll, be sure raised r_b inside ddll aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to intema_ components.
TO REMOVE BATTERY PACK
• Lock sw_tch trigger on your ddll by placing the
direction of rotation selector in center position.
See Figure 2.
• Locate latches on end of battery pack and
depress to rsiease battery pack from your drill.
See Figure 3.
• Remove battery pack from your drill.