Setting Up the LocationFree Player
for TV or Videos
You can adjust settings such as those for the TV
channel or the remote control for connected
Setting the TV Channel
from the control panel
(1 page 9), and then press the
Select [Channel Settings], and then
Select the TV tuner type.
1 Select [Internal Tuner] or [External
If you selected [Internal Tuner], proceed to
If you select [External Tuner], you may see a
message that asks you to save remote control
data to Memory Stick Duo™ media. In this
case, follow the on-screen instructions to save
2 Select the channel for antenna output
from the external tuner.
3 Select the manufacturer of the connected
4 Select the type of the connected device.
5 If the configuration above is correct, each
time you select [Power], you can turn
your device on or off.
After selecting [Power], it may take five
seconds or more for the device to respond.
If you cannot turn the power on and off, make
sure that the make and model are correct, and
then try again.
Also, check the connection between the Base
Station and the connected device, and make
sure the IR Blaster is installed properly.
6 Proceed to Step 6.
• When using a remote control to watch TV, even if
the power turns on and off correctly with [Power],
other buttons may not be enabled. If this happens,
the remote control settings may be incorrect. Adjust
the settings to use the correct remote control.
• Some devices may not have a [Power] button (for
example, some DVRs do not). In this case, after
completing the remote control settings, use the on-
screen remote control to confirm that the buttons are
Set for usage of cable TV.
Select [Off] or [On], and then press the
Using the up and down buttons,
select the desired channel, and then
Channels to be skipped by the PSP™ system
are set. When done, press the
final time to complete the setting.
When you have completed making settings
for all channels, press the right button.
Displays the number of the
channel as displayed on the
PSP™ system screen. This item
cannot be edited.
If you select [Yes], the channel
will not be displayed on the
PSP™ system when changing
channels with the PSP™
system's directional buttons or
the +/– buttons on the remote