Advertisement
TO INSTALL BATTERYPACK
•
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 3.
•
Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack. See
Figure 4.
BATI'ERY
t
PACK
TO REMOVE
BATTERY
PACK
•
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 3.
•
Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 4.
•
Remove battery pack from your ddll.
KEYLESS
CHUCK
See Figure 5.
Your new drill has a keyless chuck. As the name implies,
you can hand tighten or release drillbits in the chuck
jaws. Grasp and hold the collar of the chuck with one
hand. Rotate the chuck body with your other hand. The
arrows on the chuck indicate which directionto rotate
the chuck body in order to LOCK (tighten) or UNLOCK
(release) the drillbit.
DRILLBIT
UNLOCK
CHUCK
(RELEASE)
COLLAR
LATCHES
DEPRESSLATCHESTO
RELEASEBATTERYPACK
Fig. 4
•
Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
CAUTION:
When placing battery pack in your
_ drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to internal components,
LOCK
CHUCK
(TIGHTEN)
BODY
Fig. 5
_1= WARNING:
Do not hold chuck body with one
hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your
hand or _,our hand could slip and come in contact
with rotating drill bit. This could cause an
accident resulting in serious personal injury.
9
Advertisement
