Regulatory Information; Safety Information - Sony Aibo ERS-7 User Manual

Sony aibo ers-7 entertainment robot: user guide
Hide thumbs Also See for Aibo ERS-7:
Table of Contents

Advertisement

For Customers in
the U.S.A.

Safety Information

Owner's Record
The model number and serial number are
located inside the cover of the unit and on the
side of the supplied AC adapter. Record the
serial number in the space provided below.
Refer to the model and serial number whenever
you call upon your Sony
Link (customer service).
Model No. ERS-7
Serial No. ________________
Warning
• To prevent fire or shock hazard, do not expose
the robot to rain or moisture.
• To avoid electrical shock, do not open the
enclosure. Refer servicing to qualified
personnel only. (Contact the AIBO Customer
Link for customer service.) (page 5)
• Periodically examine the AC adapter for
conditions that may result in the risk of fire,
electrical shock, or injury to persons (such as
damage to the cords, blades, housing) and in
the event of such conditions, the AC adapter
should not be used until properly repaired or
replaced.
• Not intended for children under 8 years old.
• This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
2
®
®
AIBO
Customer

Regulatory Information

This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
The shielded interface cable recommended in
this manual must be used with this equipment in
order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC
Rules.
Note
FCC RF Radiation Exposure Statement: This
equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment. This device and its antenna must
not be co-located or operating in conjunction
with any other antenna or transmitter.

Advertisement

Table of Contents
loading

Table of Contents