Setup 5: Bundle The Cords And Cables; Setup 6: Turn On The Monitor And Computer - Sony SDM-X202 Operating Instructions Manual

Setup 5: Bundle the cords and
cables
1 Remove the arm cover.
2 Secure the video signal cable and audio cord using
the cable holder on the cabinet.
3 Bundle all of the cords and cables inside of the
stand.
4 Engage the latch on the stand as illustrated below to
hold the cords and cables.
5 Replace the arm cover and back cover.
2
Note
If you cannot bundle all of the cords and cables inside the stand, leave
them hanging down outside the stand.
1
arm cover
3
5
back cover
4
Setup 6: Turn on the monitor and
computer
1 Press the MAIN POWER switch on the right side of
the monitor in the direction of the [.
The 1 (power) indicator lights up in red.
MAIN POWER
2 Press the 1 (power) switch on the front right of the
monitor.
The 1 (power) indicator lights up in green.
3 Turn on the computer.
4 Press the INPUT button to select the desired input
signal.
The selected input signal indicator lights up and the picture
appears on the screen.
For more information, see "Selecting the input signal (INPUT
button)" on page 11.
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture (page 12).
lights in red
US
lights in green
9