Graco Husky 205 D120 Series Instructions Manual page 19

6
58
50
* 17 * 16
3
14
* 4
7
5 *
1
Used on acetal models only.
3
Torque to 45-47 in-lb (5.0-5.3 Nm). See Torque Sequence on page 20
4
Lips of u-cups (3) must face toward each other, toward center of valve carriage (2).
5
Torque to 20 in-lb (2.2 Nm).
6
Torque to 42-47 in-lb (4.7-5.3 Nm). See Torque Sequence on page 20.
7
Torque to 28-33 in-lb (3.2-3.7 Nm). See Torque Sequence on page 20.
8
Ensure properly seated in groove.
9
Not assembled. These plugs are supplied to plug the two ports in the manifold that are not used.

These parts cannot be ordered separately. They come preassembled and are included as part of the Air Valve Service Kit 238853.
* These parts are included in Air Valve Service Kit 238853, which may be purchased separately.
† These parts are included in Fluid Section Service Kit. D010xx, which may be purchased separately.
‡ These parts are included in pump with integral air valve only.
 Service kits include two types of o-rings (57): thin cross section and thick cross section o-rings. Use thin cross section o-rings on
Acetal and PVDF pump series A to E and Polypropylene pump series A to H. Use thick cross section o-rings on Acetal and PVDF
pump series F and later and Polypropylene pump series J and later. Discard unused o-rings.
51
7
6 *
30
57†
11
1
9
* 3
4
* 2
4
* 3
* 6
Parts
52
59
21
20†
8 12 10
11
8
15
51
6
60
55
54
57
30† 53
5
50
7
58
308652ZAS
61
61
1
60
9
ti10666c
19