Notes
• The motion detection function is not available when
Cropping is set to On.
• Cropping is not available when SolidPTZ is enabled.
• Video 2 image is cropped with the same setting as
Video 1.
To crop an image
1
Set Cropping to On and click the Area setting
button.
The area setting window appears.
2
Setting the trimming portion
Hold down the left button of the mouse on the still
image and drag the cursor diagonally. The area in a red
frame is the trimming portion.
3
Click OK at the bottom of the window.
The cropped image is displayed on the main viewer.
4
To close the image, click
in the upper-right
corner.
SolidPTZ
Select On to enable the SolidPTZ function.
Notes
• SolidPTZ is not available when Cropping is enabled.
• When SolidPTZ is set to On, the motion detection
function is not available.
• When SolidPTZ of Image 1 is set to On, SolidPTZ
of Image 2 can be set to On.
• When SolidPTZ is set to On, Easy Focus may not
work properly. In this case, set SolidPTZ to Off.
Codec
Select JPEG, MPEG4, H.264 or OFF. Note that Image
1 cannot be set to Off.
Notes
• The selectable size of images and frame rate for
Image 2 may be limited depend on the setting of codec
type, size of images and/or frame rate for Image 1.
• Motion detection function is not available when Image
2 is set to other than Off.
Image size
You can select the size of images sent from the camera.
The selectable size of images are depend on the setting
of maximum image size. For details on selecting
maximum image size, refer to “Installation tab” in
“System menu” in page 36.
When you set the different image size to Image 1 and
Image 2, the available combinations are as follows:
Page 44