Reboot
Used when rebooting the camera.
Click Reboot, and the message “This System will be
rebooted. Are you sure?” appears. Click OK to reboot
the camera. It takes about two minutes to restart.
Factory default
Resets the camera to the factory settings.
Retain current network settings
When this item is checked, only the current network
settings will be retained after reset.
Click Factory default, and the message “Setup data will
be initialized. Are you sure?” appears.
When you click OK, the network indicator on the
camera starts to blink. After adjustments of the default
settings have finished, the camera reboots automatically.
Do not turn off the camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of the camera while pressing the
reset button on the camera. For details, see the supplied
Installation Manual.
Backup setting data
Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera.
The file name preset at the factory is “snc-ch120.cfg” for
SNC-CH120.
Restore setting
Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Click OK, and the camera is adjusted
according to the loaded data, and restarted.
Restore preset position and Privacy Masking
settings
If you select this, the stored setting data of the camera,
the preset position data and the data of the Privacy
Masking setting are loaded.
Notes
• SNC-CH120/CH160/DH120/DH120T/DH160 do not
support the Privacy Masking function. A function that
is not installed will not be displayed.
• With Restore setting, some items in the Network
menu (page 48) cannot be restored.
• When Restore preset position and the Privacy
Masking setting is selected, it may take some time to
load the setting data.
Page 37
Configuring the System — System Menu