Using Solidptz Function - Sony IPELA SNC-CH220 User Manual

Monitor screen
There are two modes for on-screen pan/tilt/zoom
operation using a mouse: Area zoom mode and Vector
dragging mode. A control bar is displayed on the screen.
In the Area zoom mode, clicking will pan or tilt the
camera towards the center of the image, and will move
the camera in the direction that displays the area selected
by the operator and zooms in at the same time. The
operator can choose a part of the image to view and
zoom in by surrounding the area with a frame by
dragging the mouse.
In the Vector dragging mode, the camera pans or tilts in
the dragged direction. How long you drag the mouse
determines the speed. Releasing the button on the mouse
after dragging stops the panning or tilting of the camera.
You can also use the tool bar to pan or tilt.
The zoom operation using the mouse wheel is available
in all modes.
Control bar
The following operation buttons are available.
Setting
You can set the streaming method, image size,
frame rate, PTZ operation mode, trigger selection
and image codec.
Streaming start button
Starts streaming. (Appears while stops streaming.)
Streaming stop button
Stops streaming. (Appears while streaming.)
Trigger run button
Runs the selected trigger.
(Displayed only when Viewer mode from User
menu (page 64) is set to Full, and one or more
triggers are enabled in the Trigger menu (page 76).)
Preset
Select a preset position to move the camera to the
registered preset position.
(Displayed only when a camera preset position is
registered.)
Save still image button
Captures still images taken by the camera and saves
them to the computer.
Audio output volume slider
Use the slider to adjust the volume. Clicking the
button will stop sound output.
Note
This unit is not equipped with audio functions.
Control waiting time and control time for exclusive
control
Exclusive control button
24
Configuration of Main Viewer
Camera list
The camera list is displayed when Camera list is set to
On in the viewer menu, and at least one camera is
registered.

Using SolidPTZ function

You can operate the camera by using the SolidPTZ
function, which provides panning, tilting and zooming
by adjusting the position and zooming ratio from the
maximum image size, without moving the camera.
There are three modes of camera operation: Area zoom
mode, Vector dragging mode and PTZ Control bar.
You can control pan/tilt and zoom in either mode.
The available functions for the camera operation modes
vary according to the viewer display. The available
functions are as follows:
ActiveX
viewer
Operation from
a
control panel
Area zoom
a
Vector dragging
a
×
PTZ control bar
Notes
• Pan/Tilt limitation
The SolidPTZ function controls streaming by
cropping or reducing a maximum size image.
Thus, the more the camera zooms out, the less area to
be panned or tilted, and becomes unavailable at the
WIDE setting.
• Zoom
The SolidPTZ function enables you to display an area
of the cropped image from the maximum image size,
when zoomed in at the TELE setting.
And the whole area shot in the maximum image size
will be displayed if the camera is zoomed out at the
WIDE setting.
The SolidPTZ function's zoom is performed digitally;
therefore, some deterioration in image quality may be
observed at the TELE setting.
Plug-in free viewer
JPEG JPEG/ ActiveX
FLASH
× × ×
a a a
a a a
×
a a