Advertisement
APPLICATIONS
You may use this tool for the following purposes:
[] Portable charging of Craftsman EX and DieHard
7.2 Volt - 24 Volt batteries
CAUTION:
If at any point during the charging
process none of the LEDs are lit, remove the battery
pack from the charger to avoid damaging the
product. DO NOT insert another battery. Return the
charger and battery to your nearest service center
for service or replacement.
LED FUNCTIONS
OF CHARGER
LED WILL
BE ON TO INDICATE
STATUS
OF
CHARGER
AND BATTERY
PACK:
[] Red LED on = Fast charging mode.
[] Green LED on = Fully charged and in maintenance
charge mode.
[] Green LED on = When battery pack is inserted into
charger, indicates hot battery pack or that battery pack
is out of normal temperature
range.
[] Yellow and Green LEDs on = Deeply discharged or
defective battery pack.
[] No LED on = Defective charger or battery pack.
CHARGING
A COOL
BATTERY
PACK
If battery pack is below normal temperature
range, the
green LED on charger will come on. Allow battery pack to
reach normal temperature, then the red LED will come on.
NOTE: If the charger does not charge the battery pack
under normal circumstances,
return both the battery pack
and charger to your nearest Sears Repair Center for
electrical check.
[] Charge the battery pack only with the charger provided.
[] Make sure the power supply is normal household
voltage, 120 V, 60 Hz, AC only.
[] Connect the charger to the power supply.
[] Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger. See
Figure 2.
[] Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
[] Normally the red LED on charger will come on. This
indicates the charger is in fast charging mode.
[] Red LED should remain on for approximately
1 hour
then the green LED will come on. Green LED on
indicates battery pack is fully charged and charger is
in maintenance charge mode.
NOTE: The green LED will remain on until the battery
pack is removed from the charger or charger is
disconnected
from the power supply.
[] If both yellow and green LEDs come on, this indicates
a deeply discharged or defective battery pack. Allow
the battery pack to remain in the charger for 15 to 30
minutes. When the battery pack reaches normal
voltage range, the red LED should come on. if the red
LED does not come on after 30 minutes, this may
indicate a defective battery pack and should be
replaced.
[] After normal usage, a minimum of 1 hour of charging
time is required to fully recharge battery pack.
[] The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
[] Do not place the charger and battery pack in an area
of extreme heat or cold. They will work best at normal
room temperature.
NOTE: The charger and battery pack should be placed
in a location where the temperature
is more than 50°F
but less than 100°F.
[] When batteries become fully charged, unplug the
charger from power supply and remove the battery
pack.
BATTERY SHOWNCHARGING
(BATTERYSOLDSEPARATELY)
EVALUATING
(YELLOW/ GREENLED)
FULLY
CHARGED
(GREENLED)
FASTCHARGE
(RED LED)
Fig. 2
Advertisement
